TRANE® Foundation™ Packaged Cooling Gas Heat Air Conditioner, GBC036A3 Model, 100000/80000 Btu/hr Input, 80000/64000 Btu/hr Output, 208 to 230 VAC, 10.4 A, 3 kW Wattage, 4.1 hp, 3500 rpm Rotational Speed, 60 Hz Frequency, 3 ph, Scroll Compressor, 1200 cfm, 12 EER, 14 SEER, 3 ton, 3 Burners, 2 Stage, R410A Refrigerant, 79 dB Decibel, Rooftop Mounting, 1/2 in Connection, 1 in or 3/4-14 FNPT Drain Connection, 16 x 16 x 2 in Filter, 0.8 % Steady State Efficiency, Steel, Galvanized/Zinc Coated, 76.814 in L x 47.934 in W x 45.558 in H Dimensions
Model |
: |
GBC036A3 |
Input BTU Rating |
: |
100000/80000 Btu/hr |
SEER Rating |
: |
14 |
Voltage Rating |
: |
208 to 230 VAC |
Amperage Rating |
: |
10.4 A |
Phase |
: |
3 ph |
CFM Rating |
: |
1200 cfm |
Mounting Type |
: |
Rooftop |
- Allows system to operate in cooling below 45 deg by maintaining head pressure by cycling the outdoor fan motor allowing safe system operation without indoor coil icing
- Provided for field conversion of gas heat units from natural gas to propane
- When installed in the economizer control circuitry, this accessory provides a method to remotely adjust the minimum damper position
- Tool-less, hail protection quality coil guards shall be field-installed for condenser coil protection
- For added water integrity, foundation has a raised 1-1/8 in lip around the supply and return of the downflow units to prevent water from blowing into the ductwork
- The Foundation™ 3 to 5 tons units match the footprint of specific carrier WeatherMaker® units
- All of Foundation™ designs were rigorously rain tested at the factory to ensure water integrity, Foundation™ units incorporate either a one piece top or the Trane® Tite-Top (T3)
- Save time and money tracing wires and diagnosing the unit
- This 24-volt control includes the control transformer and contactor pressure lugs for power wiring
- Product efficiencies meet the requirements of ASHRAE 90.1 - 2016
- All panels in the evaporator section of the unit have cleanable foil-faced insulation, all edges are either captured or sealed to ensure no insulation fibers get into the airstream
- All Foundation™ units have cooling capabilities down to 45 deg F as standard
- All indoor fan motors are belt drive as standard
- Low and high pressure cutouts are standard on all Foundation™ models
- Remove four or less screws for access to the standardized internal components and wiring
- Single side service is standard on all units
- Every Foundation™ unit has a non-corrosive, sloped drain pan made of rigid PVC standard on all units that is removable for easy cleaning
- Convertible airflow
-
Catalog
https://assets.unilogcorp.com/267/ITEM/DOC/Trane_GBC036A3EMA0000_Catalog.pdf
-
Instruction/Installation Manual
https://assets.unilogcorp.com/267/ITEM/DOC/Trane_GBC036A3EMA0000_Instruction_Installation_Manual.pdf
-
Specification Sheet
https://assets.unilogcorp.com/267/ITEM/DOC/Trane_GBC036A3EMA0000_Specification_Sheet.pdf